English

Stock Santa Cruz 50 with stern scoop. Yanmar engine upgrade. Clean and ready to go sailing or detail her out for racing and mix it up with the strong Santa Cruz 50 fleet. 

Upgrades

• Boom new 1998
• Rod Rigging 1998
• Antal Mainsail Track and Bat Cars 1998
• Custom Chain Plates 1998
• Profurl furling 1998
• Vacu Flush fresh water head
• Isotemp hot water heater
• Turcite Rudder Bearings
• Custom Anchor roller

Builder's Original Description

The Santa Cruz 50 is designed, engineered and constructed with the same care and experience typical of Bill Lee yachts, from the Santa Cruz 27 to Bill Lee's own "Merlin" Hull and deck are hand-laminated of multiple layers of fiberglass mat and roving impregnated with polyester resin. Vacuum bagged balsa core provides stiffness and strength without unnecessary weight. The deck is cored with plywood inserts in areas of high stress. Hull and deck are bonded with polyester adhesive, and through-bolted with the aluminum toe-rail. Deck hardware is through-bolted with stainless fasteners (Type 18-8), and backing plates. where necessary.

 

Hardware is Mariner, Schaefer, and Nicro-Fico. Winches are Barient. Windows are G.E. mar-resistant Lexan, tinted solar-control bronze. The foredeck hatch is an extra-large Bomar. Other hatches are custom-built by Bill Lee Yachts.

 

The mast is a double-spreader tapered extrusion with Navtec rod rigging. Navtec U-bolt chainplates tie directly to a cross-arm and the aluminum mast step I-beam for maximum strength. Four function hydraulics are standard.

 

The electrical system is controlled at a Marinetics breaker switch panel, through a three-position battery switch from two batteries. Included are both an ammeter and a volt meter. Most lights are provided with white and red bulbs~for improved night vision. The standard engine is a Pathfinder 50 (42 H.P.) (UPGRADED TO YANMAR 38HP) diesel driving an 18" Martec folding propeller

through a 1" stainless steel shaft.

 

The keel for the Santa Cruz 50 is a solid lead casting bolted to the keel stubby with 1" stainless steel (Type 316) bolts. Faired and permanently covered in fiberglass, the keel is bonded to the hull for extra strength, stiffness and crunch-protection. Pedestal steering with a large-diameter wheel drives a 4" rudder shaft through a 12" disc drive.

 

Interior cabinetry and bulkheads are bonded directly to the hull. There are no floating bulkheads and no liners. Woodwork is beautifully finished Bruynzeel marine mahogany plywood of the highest quality.

 

Special interior features include a private owner 5 stateroom aft of the main cabin, with separate access from the cockpit, two double bunks, standing headroom, a hanging locker and extra storage in two seat lockers. Opening ports in the cockpit and transom, and flush windows in the hull, give plenty of ventilation and light for the aft stateroom.

 

The enclosed head offers standing headroom, marine head with holding tank, sink and fresh water pump.

 

The galley is equipped with a Gas Systems 3 burner stove with oven, fresh and salt water foot-pumps, large stainless steel double sink, large icebox and a trash bin. The famous "Merlin" settee arrangement is standard. The settee floor is raised to allow for storage and the crew's beer icebox. Seating is with the cabin windows at eye-level. The settee bunks are easily convertible from single bunks into doubles. Including the V-berth forward, there are five double bunks on the boat, any of which can be used as singles with lee cloths. Spacious storage is available under all bunks.

 

Opposite the galley is the navigator's station. This includes a seat, a large chart table with plenty of storage for books, instruments and space for electronics.

The 50's forward cabin is open, light and airy, keeping unnecessary weight out of the ends of the boat, and providing a large open living area, as well as plenty of sail stowage. An extra-large foredeck hatch eases sail handling. A second companionway gives access to the main cabin from the deck, as well as providing ventilation for the galley.

 

The large cockpit has comfortable secure seating for a cruising crowd. Sheet winches are mounted on a large winch island at the optimum height for efficient operation. The extra large wheel is mounted aft for best visibility and control allowing a variety of steering positions for any helmsman and situation. A lazarette hatch gives access to the transom

windows and steering gear, with a large canvas bag for storage.

 

There are no exotic materials in the Santa Cruz 50. Bill Lee prefers to build with known materials and methods, rather than experiment at the owner's risk. Bill has proven over the years that he can build a light, strong boat without overstepping the bounds of good judgment and solid experience. No production builder of yachts in the Santa Cruz 50's size range can make the same claim. Bill Lee's reputation, backed by quality workmanship, assures you of the finest, strongest, fastest 50-footer you can buy.

Disclaimer

The company offers the details of this vessel in good faith but cannot guarantee or warrant the accuracy of this information nor warrant the condition of the vessel. A buyer should instruct his agents, or his surveyors, to investigate such details as the buyer desires validated. This vessel is offered subject to prior sale, price change or withdrawal without notice.

General information

Make/model	Santa Cruz 50
Category	Used sail boat for sale
Price	£76,481 GBP | Listed price $99,000 USD
Name of boat	Main Squeeze
Year	1982
Length overall	16.46 metres
Location	Marina Del Rey, California, United States