Specialist 0 (Same as Atlas 618) "thread cutting" metal turning lathe with the Timken bearing headstock. Operates on basic 110 volt air conditioning household voltage. This lathe has a 6" turning diameter (3" turning radius), 18" center to center, and 1/2" headstock thru bore.

　　The lathe was just recently cleaned and newly oiled. Everything works good, consisting of the "thread cutting" cross feed.

　　There following is included:

　　... lathe.

　　... motor.

　　... 3 jaw chuck.

　　... chuck secret for the three jaw chuck.

　　... one set "within" jaws for three jaw chuck.

　　... one set "outdoors" jaws for 3 jaw chuck.

　　... board lathe is mounted on.

　　... tool post.

　　... one cutting bit.

　　... one face plate.

　　... five equipments (in addition to what is already installed on the lathe).

　　... one live center.

　　There is NO other tooling with this lathe. If it isn't in the photos, it is not consisted of.

　　The sale does NOT consist of the cart that it is sitting on.

　　The cost is firm at $675. I might think about interesting "TRADES". I am not trying to find anything in particular. Simply open to ideas. I would have an interest in a used John Deere yard tractor of comparable value. I could even add a little money for a great one. "NO" scrap brand names !!!

　　This lathe is situated in the Northwoods location of Jacksonville off of Henderson Drive.