If interested please contact [email protected] keep in mind this photo is poor quality because it is a phone pic of the boat on my computer screenbetter photos are avail upon request. 1988 Chris Craft Stinger 312. This boat was re-worked in 2. New twin 500 HP Ford 460 motors. Engines- hydraulic roller cam/roller rockers,Sealpower 30 over forged pistons,ARP rods/mains/head bolts,acid dipped exhaust manifolds and rises,Edelbrock air gap intakes/750 carbs with metering rods and 119 jets,Pro comp aluminum heads, lightened flywheel from 42 lbs to 22 lbs, MSD 6al box w/distributor and 8.8 wires,Mallory coils,Autolight racing plugs,new starters and altenators. Engine compartment-New trim pump and trim tabs/blowers/batterys/lift pumps/throttle and shift cables/steering wheel and cables/ purple neon lighting/ 4" thru hull exhaust. Paint- Custom paint with airbrushing Exterior features- New stainless Hydro Marine props/nose cones, outdrives also airbrushed to go along with paint scheme, neon lighting under the swim platform Cabin features- new vinyl/tweed interior, bed, fridge, Cockpit features- Lavorsi monster gauges with carbon fiber and race rims, GPS speedo/casper knock gauges and 02 sensors, custom black plexi dash panel, neons, Alpine cd head unit with 2 controllers 1 on dash 1 under swim platform (controls whole audio system while you can stay in the water and not have to get back in the boat) 4 pair of JL 6.5, 4 JL 12w1's flush mounted under the rear seat, 2 JL 300/4 amplifiers. Boat has been stored inside since the rebuild in 2008. ONE THANG WITH OMC KING COBRA'S THE ENGINE HAVE TO BE SHUT DOWN TO SHIFT REVERSE TO FORWARD AND FORWARD TO REVERSE MAKES IT A LITTLE DIFACULT TO DOCK Any one that would like to take it for a trial run just email me. serious inquiries [email protected] originally posted at http