1988 Yamaha FZR 1000 "Genesis"I have owned this bike for 20 years, and I am the 2nd owner. I am now 68 years old and can no longer ride a sportbike after double knee replacement surgery. Time for someone else to enjoy it. The bike sat for nearly 3 years after the fresh engine and transmission so a complete maintenance routine was performed.... see below.This bike is a bit of a "sleeper".... while retaining its stock paint and outward appearance, it has several modifications. * Wiseco 1029cc piston kit* 6-speed transmission with "back-cut" 1st, 2nd, 3rd, and 4th gears.* Vance & Hines pipe* Dyno-Jet Stage 3 jet kit* Ported and Polished head* Polished intake runners* Stock airbox with K&N Filter* Fresh Rebuild of: Carbs Clutch Slave Cylinder Clutch Master Cylinder Front Brake Calipers Rear Brake Caliper Front Brake Master Cylinder * New Tires, (Angel GT's) * New plugs* Original owners manual and purchase orderHere is the story on the engine rebuild. When I picked the bike up from the original owner he was not home immediately. I could hear someone doing a hole-shot, or attempting to do a burnout a street over. Guess who? Yeah, the owner was giving it one last reaming. I was pissed! He said yeah, I wanted to ride it one last time, I saidRIDE? Sounded to me like you were reaming the butt off of it!! I made the mistake of not test riding it at that point. His reply was that the bike wasn't hurt and it ran fine. So I completed the sale. When I rode it home it seemed to run fine so I didn't worry about it. After a couple of weeks it began to pop out of 2nd gear. Not uncommon for Yamaha's in my experience. So, I called my mechanic to see if he would take a look. He found a piece of a clutch disc in the clutch basket. The good news was it had a Barnett clutch basket in it! He put all new clutch plates in it and it shifted fine, but it still popped out of gear at times.At that time I met a fella that told me that a 6-speed transmission (factory was 5 speeds)was a drop-in unit. I was like, no way!! He said find a nice, low mileage FZ750 and grab the tranny. Its a drop in, bearings and all! So I found one on Ebay, a nice low mileage unit and bought it. I had the first four gears machined with a back-cut to solve any popping out of gear problems once and for all. It works flawlessly!!! At the same time I priced a Wiseco big-bore piston kit. I thought why not, while we're doing the tranny and my mechanic agreed. He was excited now!! So, a fresh big-bore kit and a 6-speed tranny... with the 6-speed it stays in the RPM range and runs like it was made for it! And it NEVER popped out of gear again. I think we replaced both sprockets at that time as well. I changed the teeth on one of them but I can't remember the details right now.This bike comes with a book that I put together that includes all work done. And it does contain a parts manual. Receipts for NOS parts that I purchased over the years, etc. A wealth of info. Original Shop Manual Included.As a final note, I got the bike out last week for a final test ride and it has a slight sputter or flat spot at about 5 RPM, should require just a bit of minor fine-tuning. I do not offer shipping on this bike. I prefer the new owner pick it up and pay cash at time of pick up. I will hold the bike for a maximum of 7-10 days until the new owner can arrange his/her shipping. I have a clean OHIO title in hand. ** I also have numerous NOS parts for this bike that I have collected over the years. These will be available for purchase to the new owner. Not included with the bike!! Including new: NOS Right and Left Sidecovers NOS Front Fairing (rare, hard to find) NOS All Decals for Front Fairing NOS Decals for both Side Covers NOS Large Black "YAMAHA' Decals for Lowers NOS Rear Finish Panel NOS Rear Tail Light NOS Seat Cover Numerous NOS parts and hardware Numerous hard to find USED parts Original 5-speed Transmission Original PistonsTHANKS FOR LOOKING & GOOD LUCK!