I have gone thru and rebuilt the brake system and fuel system. The wiring has been replaced with a new harness and it has a 12volt conversion. All the rubber and glass has been replaced, I have new wood in the bed, and a new chrome grill. The original interior has been restored and is very clean with the only non original part being custom door panels. The trucks frame is super clean and completely rust free. The entire body is pretty much rust free except for 3 small areas. Both rear cab corners have been repaired but the job was not a good one, so although the little rust that was there was taken out the areas could still be repaired properly if needed, otherwise it is ok. The only remaining area needing to be cut out and replaced is the driver floor board. There was a leak of the oil pressure line that went unnoticed and it caused the floor to split open at the crease, its a simple fix.